- Custom tool profile in MADCAM ?
-
Member
Custom tool profile in MADCAM ?
Folks: Is it possible to set up a custom tool profile in MADCAM ? I can not find an answer in any of the MADCAM posts. Thanks
Similar Threads:
-
-
Community Moderator
Re: Custom tool profile in MADCAM ?
Not what I know unfortunately. I know there are ball cutters simulated for making undercuts and curved tubes (engine intake) but not sure how it is implemented in the code though.
-
Member
Re: Custom tool profile in MADCAM ?
It turns out it is a ball cutter that I need to use in MADCAM. I need to cut the interior profile in some boxes and need to make an undercut. Perhaps I can "trick" the program somehow if I can find the proper deep "spherical" router bit.
Thanks
- Custom tool profile in MADCAM ?
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules