- Simple newbie Madcam question
-
Registered
Simple newbie Madcam question
Hi-
I'm trying out the demo version of madcam, coming from the too expensive rhinocam... Is there a way to do simple 2 1/2d in madcam, as there is in rhinocam?
Simple profiling, drilling?I'm using Rhino 6, and I see no menu item for 21/2d in the madcam menu tab.
Thanks-
Dan
Similar Threads:
-
-
Registered
Re: Simple newbie Madcam question
Oh-
I see- it is under the 3d menu as "profiling"... Now when I try specifying a cut "outside" it just cuts inside the line and won't stay on "outside", but I think I'm getting the hang of it.
-
Community Moderator
Re: Simple newbie Madcam question
You specify the side by moving the simulated tool before entering the dialog.
There are some movie clips here, getting a bit old but the routines for the basic stuff are still the same.
MADCAMCNC
- Simple newbie Madcam question
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules