Cutting

[Olavi]

I try to do some cut >> 2015-01-14_1634 - OlaviJing's library

Same method is ok but starting place >>2015-01-14_1641 - OlaviJing's library

Similar Threads:

• Problem- SteelTailor provide cutting parameter table for flame cutting operation?
• Problem- Problems of setting plasma cutting mode of SteelTailor SmartIII CNC cutting machine
• New Product- Cutting Quality Makes TubeTailor I Tube Cutting Machine Stand Out
• LIMAC fiber laser cutting machine for stainless steel cutting video

[svenakela]

...and the problem is?..

[Olavi]

Yes, should be able to understand what I wanted, but it does not matter anymore when I got it done, that is, this is what I wanted>>2015-01-14_1850 - OlaviJing's library

[svenakela]

Yes, should be able to understand what I wanted, but it does not matter anymore when I got it done, that is, this is what I wanted>>2015-01-14_1850 - OlaviJing's library

Actually there are no clues to what your problem was. Your simulation looked like an edge rounding operation and that is completely legit.

[Olavi]

I am sorry for the English language skills are poor, and I use a translator, so I understand that often I can not tell you what I'm trying to do.
I am very pleased with MAdCAM in the program, and the advice that I have received.
I have built a 5-axis machine itself, and I'm learning to use MAdCAM, I have already done during the week saanu toolpaths.
Kai

[Olavi]

More question: If you do this way whether straight cylinder bore.
I use the same blade as the video

[Olavi]

Could this question to get an answer.
Will there be a hole in the straight, or a cone, with this method?

[Dan B]

It's hard to tell from the video, but I would think the hole would be straight if the angle of the tool approach is greater than the taper.

Would it gouge if it was less? I don't know for sure, as I've never had a scenario like this. If I was doing this I would use a traditional ball nose cutter and do an indexed path. But I'm not in the jewellry world so maybe there is a reason for this type of path.

[Olavi]

Thanks for the advice I ask more about that later.
Now there is another serious problem.
Milling of this ring, and this is a simulation>>>2015-01-17_1649 - OlaviJing's library
It looks pretty good, but the result is that which is reflected in the image.
Z-value is too low,, let me know what is wrong,, when it makes that the toolpath?
Z-value is not allowed to go below 10mm