- Newbie- Simulate Shows cutter inside part.
-
Registered
Simulate Shows cutter inside part.
So I'm attaching a picture of my simulate and the machine settings next to it. When I am doing a 4 axis toolpath (parallel finishing) the simulation is showing the cutter inside the part. The code posted seems ok, haven't ran it just yet to verify. But is there a way to flip the cutter around 180?
The other thing is on my lead in I have it set to 1.5" just because our machine runs somewhat fast and I want to make sure the approach starts outside the part. But the approach angle is opposite direction the cut actually goes. Is there a way to make the angle the opposite so it travels with / along the cut path? I tried putting a negative angle, as well as the angle past the 90 but they both just made a 90 degree angle.
Thanks
Similar Threads:
Last edited by 9r2a5m70; 12-09-2014 at 06:36 AM.
Reason: Remembered other question.
-
- Newbie- Simulate Shows cutter inside part.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules