- Rapidly dulling end mills?
-
Member
Re: Rapidly dulling end mills?
You could phrase that as too much rubbing in the dust!
You can solve a lot of that with a continuous air blast aimed at the cutter. It will cool the cutter and clear out the swarf. Then you could probably run continuous. Downside is that you need a compressor. Plenty of us use an air blast.
Cheers
Roger
-
- Rapidly dulling end mills?
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules