How to use Z Axis Pre-setter Tool Setter?

Results 1 to 2 of 2

Thread: How to use Z Axis Pre-setter Tool Setter?

  1. #1
    Registered mikejohn37's Avatar
    Join Date
    Aug 2014
    Location
    Australia
    Posts
    48
    Downloads
    0
    Uploads
    0

    Default How to use Z Axis Pre-setter Tool Setter?

    Could someone please explain how to use this z axis setter? And, it has two set screws underneath but what do they do?

    Mike

    Similar Threads:
    Attached Thumbnails Attached Thumbnails How to use Z Axis Pre-setter Tool Setter?-s-l500-jpg  


  2. #2
    Member
    Join Date
    Oct 2004
    Location
    usa
    Posts
    178
    Downloads
    0
    Uploads
    0

    Default Re: How to use Z Axis Pre-setter Tool Setter?

    the bar is for calibration. Lay it across the piston and the side of the setter, pushing it all the way down. The dial indicator should read zero. Put the setter on top of your part and bring the tool down until the dial reads zero. Knowing the height of the tool setter (usually 2" or 50 mm) you now have your tool height. Enter the tool setter height in the Z column of the G54 offset table and you're good to go.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

How to use Z Axis Pre-setter Tool Setter?

How to use Z Axis Pre-setter Tool Setter?