- Looks like I may have missed a few posts. Yikes
-
Registered
Looks like I may have missed a few posts. Yikes
There have been 1,345,847 posts and 201,296 threads since your last visit at 10:11 PM 08-10-2007.
The time is currently 11:26 AM, on 04-07-2018.
Guys and Gals.
I am looking for advice/comments as to how to proceed. I just purchased a complete CNC setup minus the table, x axis and overarm beams as the seller was going to reuse those on another project. I will be building my own table to be used as a plasma and router setup. The pictures enclosed are what it looked like before the seller took the thing apart. I have never seen a setup such as this and it looks totally overkill. My question is would whether I would be better off building a table that looks like whats in the enclosed pictures or looking to find another ball screw for the A axis in a gantry style table. I will be building a table 3'x4' based on what I have for ball screws.
I have the X,Y and Z ball screws but will need to get another to run an A axis to supplement the Y axis if I go the gantry route and am trying to id what I have for screws so that i might match what i currently have. Any and all comments appreciated.
Similar Threads:
Last edited by Jammer; 04-07-2018 at 01:39 PM.
-
- Looks like I may have missed a few posts. Yikes
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules