I have just replaced my number one router controller with a new TB6600 bob and ESS Warp 9 and wired it all up with the spindle and VFD. I had to sort through the differing advice on this forum and settled on mactec54's advice and instructions. Worked first time and I have confidence that it is all wired up safely and properly.
The old black box controller I was using has a bob in it that no one has been able to recognise or name. The supplier has not been forth coming with information on it either.
So this is currently running the no 2 router.
Having to put a S command on every Z axis movement is going to be a pain in the butt, so will look to see how else the switching can be accomplished.
I have 3 options;
The TB6600 4 axis bob has 2 relays, I have a spare, and the 3 axis bob has 3 relays, but no pwm out, just 10v on or off. However this could activate a relay with 5v for the TTL to trigger.
The DB25-1205
XHC MK4 usb 4 axis bob and drivers. Been sitting in the draw for some time.
I'll play with the DB25 first, I want to be able to run both spindle and or laser off the same setup without having to switch things around.