Mach3 One stepper motor won't move

[dbulldog62]

I am replacing my computer on my plasma table. I loaded Mach3 on the new computer set it up with the same setting as the old one. Everything works as it should except one of my motors on the Y axis won't move. I plug in the old computer works fine. HELP!

Similar Threads:

• Need Help!- GRBL 1.1 Stepper motor won't move
• my stepper motor NEMA 23 do not move but make a little noise
• my X axis stepper motor doesn't want to move sometimes on the nm145
• Stepper motor move barely!need help
• How to you make a stepper motor move?

[number40Fan]

USB or parallel port?

[dbulldog62]

USB or parallel port?

Parallel port

[number40Fan]

Double, triple, quadruple check the pin layout in Mach 3. If that doesn't work, can you swap the ports between the two computers?

[Sterob]

You have 2 Y axis Steppers?
Have you set one to slave to the other?