goto zero single axis
Member
goto zero single axis
Hi all, great forum and very useful for us newbies.
My question is what is the easiest way to send only the the Z axis to its zero position? Similar Threads:
Member
Re: goto zero single axis
Manually you can just enter the gcode to go to Z0, or set up button(s) that will do it without typing it in. You need to do some research on Gcode and read the Mach manual.
Member
Re: goto zero single axis
If doing it often I'd edit an existing G code in notepad for G0 ZO.
I have one saved for G28 at days end.
Something like this I edited from a previous slot program.
(3MM SLOTS)
(T3 D=3. CR=0. - ZMIN=-17. - FLAT END MILL)
G90 G94 G91.1 G40 G49 G17
G21
G90
(SLOT3)
G0 Z0.
M30
This will only move Z to 0. Just load and start.
Member
Re: goto zero single axis
Thanks guys, great help as always.
goto zero single axis
Tags for this Thread
Posting Permissions
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
Forum Rules