You must be using a custom home macro. By default, Mach3 should only back off until the switch opens, and not do any movement at all.
Hello,
I have converted an XpertMill to run under mach3. I use the limit switches as standard on the machine. That means Y must home to its +1000mm pos. I have set positve homing and the home offset to 1000.
Now the machine runs positive to the switch, want to back of competely to 0 and then slowly to 1000. How can I set that it backs of only to 990 or so and then slow to 1000again?
Kind regards
Ronald
Similar Threads:
You must be using a custom home macro. By default, Mach3 should only back off until the switch opens, and not do any movement at all.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)