- Fanuc 18T on Ikegai TU-15
-
Registered
Fanuc 18T on Ikegai TU-15
Hello All,
We have a 1994 Ikegai TU-15 turning center with a Fanuc 18T control. We just lost all the parameters as I think the battery for the control died. Does anyone have these parameters and information on where to get/how to replace the battery?
Thanks!
Ed
Similar Threads:
-
-
Registered
I work on 3 of these, I'll see what I can find out.
Whoops... ours are OT-9, not sure if you can use the basic parameters?
-
Registered
Hi Ed,
I'm Tom. Did you get your Ikegai back up and running? Does yours have a C axis/live tooling? If so, can you rigid tap w/ the live tooling and what is the code? Mine is an TUR15 w/ Fanuc 18-T control.
-
Member
Re: Fanuc 18T on Ikegai TU-15
Hello, Hope everyone is doing well.
I am looking for a copy of a Ikegai TUR15 with a Fanuc OT model B, Live tooling.
Even a print out of the the ladder. IF you have the eproms I can read them.
- Fanuc 18T on Ikegai TU-15
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules