I have searched this Forum for info on this subject. I can't find anything. If anyone knows of a thread I missed, please direct me. Thanks in advance.
Hello, I am trying to DNC from 9 pin pc to 25 pin Prototrak MX3. I have tried several combinations. I always seem to get the error about control receiving data too fast. It’s like the XOFF isn’t working. I’m pretty sure it’s the cable. I am using 3 wires. Any help would be appreciated.
Thanks
Similar Threads:
I have searched this Forum for info on this subject. I can't find anything. If anyone knows of a thread I missed, please direct me. Thanks in advance.
I think this device can help you
https://www.ebay.com/itm/USB-Reader-...YAAOSwI4VdLJxN
It could be the handshake, because you say your getting an error which is good. The PC send, through your comm port device, via serial RS232 cable, to the port - so now you need to check parameters to match CNC and software, and then verify the handshake.
Have you tried to send from the CNC to computer?
What serial port hardware are you using, and software?
Regards,
Greg Mercurio
Shop Floor Automations
www.shopfloorautomations.com
Greg Mercurio
Shop Floor Automations, Inc.
www.shopfloorautomations.com
(619) 461-4000 Tel