DNC Unable to Keep Flow of Data


Results 1 to 4 of 4

Thread: DNC Unable to Keep Flow of Data

  1. #1
    Registered rrreed44's Avatar
    Join Date
    Dec 2018
    Posts
    0
    Downloads
    0
    Uploads
    0

    Default DNC Unable to Keep Flow of Data

    We just connected a new pc to our machine and all of our settings look to be set right (even in reference to the old laptop's settings). We are able to fully load small programs into the machine but if we attempt to use the DNC with a drip feed then it seems to error out. Usually when we cancel the run there will be 5~8 lines loaded into the machine but nothing else will load. Any ideas on what could be causing this issue? I took a couple of screenshots of the settings on the pc and took a picture of the machine's screen to show what we have setup. Any help is greatly appreciated! Thanks!

    Similar Threads:
    Attached Thumbnails Attached Thumbnails DNC Unable to Keep Flow of Data-untitled-jpg   DNC Unable to Keep Flow of Data-untitled2-jpg   DNC Unable to Keep Flow of Data-20181204_133629-jpg  


  2. #2
    Member dcoupar's Avatar
    Join Date
    Mar 2003
    Location
    USA
    Posts
    2923
    Downloads
    0
    Uploads
    0

    Default Re: DNC Unable to Keep Flow of Data

    Are you using a USB to Serial adapter? (I seem to remember having similar problems with these in the past.) If so, you might consider buying or building a custom cable to eliminate the adapter.



  3. #3
    Registered
    Join Date
    Jul 2004
    Posts
    169
    Downloads
    0
    Uploads
    0

    Default Re: DNC Unable to Keep Flow of Data

    What is the make and model of the controller?

    115K seems extremely fast without Xmodem. Are you using a USB to serial adapter....make and model ?

    Greg Mercurio -Shop Floor Automations
    www.shopfloorautomations.com /619-461-4000


  4. #4
    Member
    Join Date
    Mar 2016
    Location
    Poland
    Posts
    167
    Downloads
    0
    Uploads
    0

    Default Re: DNC Unable to Keep Flow of Data

    U have a different flow control on a computer and on the machine.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

DNC Unable to Keep Flow of Data

DNC Unable to Keep Flow of Data

DNC Unable to Keep Flow of Data