Check out Paul's post in this thread. He details how to calculate the "unit horsepower" for various materials:
http://www.cnczone.com/showthread.php?threadid=203&s=
is need for a mini Vertical mill, should it be geared down? Is 130 in oz enough with a 2 to 1 gear ratio? I want it to have enough power to hog out steel.
Similar Threads:
Thank You,
Paul G
Check out-
[URL="http://www.signs101.com"]www.signs101.com[/URL]
Check out Paul's post in this thread. He details how to calculate the "unit horsepower" for various materials:
http://www.cnczone.com/showthread.php?threadid=203&s=
First you get good, then you get fast. Then grouchiness sets in.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Ah that is very helpful, . How did I miss that post? Thanks man!
Thank You,
Paul G
Check out-
[URL="http://www.signs101.com"]www.signs101.com[/URL]