Offset the lines by 1/2 the tool diameter.
newbie question here. When you cut pieces for intarsia from a line drawing, how do you allow for the diameter of the tool so the pieces aren't too small?
Similar Threads:
Offset the lines by 1/2 the tool diameter.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
how does it know which direction to offset then in? e.g. a circle?