Make sure the Probe LED lights up when you touch the plate to the bit.
I am running mach3 BOB PMDX-122 Gecko drive G203v.
been running for a few years with no problems.
just had a problem popped up i went to zero to the table top using the zero plate
when i ran the zero. The spindle moved down but did not stop when it touch the plate. have to hit the page up for it to go back up.
.
any idea where to start looking to correct this?
Paul
Similar Threads:
Make sure the Probe LED lights up when you touch the plate to the bit.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)