Maybe you just got lucky with the first two?
If Mach3 is not starting the spindle, then it's the controller.
Happened twice in 2 weeks. My spindle starts suddenly without my command. I was sitting and playing with my phone and suddely i see that spindle starts to turn. I use chineese mach3 ethernet controller. I know there is no trust on chineese controllers but this is my 3rd controller from this brand. the other two work fine. My spindle is HERTZ 2.2kw trukish brand which is fine. VFD is again chineese brand called LiteOn EVO6000 1 to 3 phase. Controller commands vfd through PWM.
Similar Threads:
Last edited by safaenet; 10-04-2020 at 12:29 PM. Reason: additional info
Maybe you just got lucky with the first two?
If Mach3 is not starting the spindle, then it's the controller.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)