Program getting stuck on m3


Results 1 to 2 of 2

Thread: Program getting stuck on m3

  1. #1
    Member
    Join Date
    Oct 2017
    Location
    United States
    Posts
    7
    Downloads
    0
    Uploads
    0

    Default Program getting stuck on m3

    Hey everyone, hope you are all doing great.

    I’m having an issue where I will run a program and it will run fine for maybe 1 run, maybe 20 runs. Sooner or later it will get stuck on line 3 and never do anything. If I stop the program and reload it, it won’t work. The only way to get it working again is to reload Mach 3.

    I’m calling the gcode that bobcad gives me a “program”.

    If it gets stuck on line 3, the status will usually say which end mill I’m using. If I just hit start run again like I would if I changed tools, nothing happens.

    I’m not really sure what’s going on. Any help or advice is greatly appreciated.

    Similar Threads:
    Attached Thumbnails Attached Thumbnails Program getting stuck on m3-14879f66-9250-42a1-8240-09dd97782379-jpeg   Program getting stuck on m3-d25913ce-56cd-468b-933b-cb323cae699a-jpeg  


  2. #2
    Member
    Join Date
    Nov 2013
    Posts
    635
    Downloads
    0
    Uploads
    0

    Default Re: Program getting stuck on m3

    Hi,
    try putting the macro M03 on a separate line.

    Craig



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Program getting stuck on m3

Program getting stuck on m3

Program getting stuck on m3