I’m having an issue where I will run a program and it will run fine for maybe 1 run, maybe 20 runs. Sooner or later it will get stuck on line 3 and never do anything. If I stop the program and reload it, it won’t work. The only way to get it working again is to reload Mach 3.
I’m calling the gcode that bobcad gives me a “program”.
If it gets stuck on line 3, the status will usually say which end mill I’m using. If I just hit start run again like I would if I changed tools, nothing happens.
I’m not really sure what’s going on. Any help or advice is greatly appreciated.
Reply with Quote
Program getting stuck on m3
