G31 command stops since moving to Ethernet SmoothStepper


Results 1 to 1 of 1

Thread: G31 command stops since moving to Ethernet SmoothStepper

  1. #1
    Member
    Join Date
    Jul 2003
    Location
    Ontario, Canada
    Posts
    138
    Downloads
    0
    Uploads
    0

    Default G31 command stops since moving to Ethernet SmoothStepper

    G31 command stops since moving to Ethernet SmoothStepper

    I have a z-height and center finding macro I have run for many years that make use of the G31 command. They failed when I moved to my ESS and after some trouble shooting I discovered the G31 command is no longer working. Even when entered as a MIDI command noting happens, For example, G31 Z1 F10.

    I have done some searching here and found a few similar observations but without a definitive solution.

    The probe LED does work via the diagnostic page as expected

    Please refer to the image for wiring of my probe port.

    Mach3 versions tested are below and I have also tested from a Dell Laptop and HP Thin client both running Windows 10.

    Mach3 Version R3.043.062
    Mach3 Version R3.043.066

    ESS Version: ESS 2019_02_25 10w2a-10f1

    G31 does not move and axis as a midi command however G32 work just fine.


    Any help would be appreciated... Thx.

    Similar Threads:
    Attached Thumbnails Attached Thumbnails G31 command stops since moving to Ethernet SmoothStepper-c10-probe-wiring-jpg  


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

G31 command stops since moving to Ethernet SmoothStepper

G31 command stops since moving to Ethernet SmoothStepper

G31 command stops since moving to Ethernet SmoothStepper