Reply with QuoteSounds like you have an inch-mm conversion issue between Aspire and UGS.
Scaling problem
Hey everyone!
I sure do hope someone could help me with my problem, I am a total beginner after all. I just built my cnc routing machine. I am (trying to) work with Aspire and Universal G-code Sender. So the problem I have is that I draw a simple shape such as a square to be 50mm by 80mm and then the machine creates a square like 3mm by 2mm. I do not understand where the problem lies because I have already calibrated the machine in the x, y and z directions. Any help will be appreciated greatly!
Many Thanks
Kevin
Similar Threads:
- Need Help!- CNC6040 XYZ scaling problem
- Need Help!- Scaling mismatch problem
- PCB Scaling problem
- Need Help!- Scaling problem
Re: Scaling problem
Sounds like you have an inch-mm conversion issue between Aspire and UGS.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
