Reply with Quote1) Increase acceleration.
2) Create toolpaths that "roll around" the corner, leaving your part square.
3) I think there's a CV wizard to setup the CV controls.
How to stop rounded corners in Mach 4 ???
Hi Everyone
I am having a hard time here, my projected tool patch has sharp corners but when i run the program it rounds them off.
I changed Motion Mode to Exact Stop from Constant Velocity, it fixed the problem but the machine now runs super slow in the
radius or rounder parts of the program.
Thanks in advance
Biggs
Similar Threads:
Re: How to stop rounded corners in Mach 4 ???
1) Increase acceleration.
2) Create toolpaths that "roll around" the corner, leaving your part square.
3) I think there's a CV wizard to setup the CV controls.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Re: How to stop rounded corners in Mach 4 ???
Hi,
the rule is that you ensure that your machine is tuned for the highest reliable (no lost steps) acceleration consistent with the rigidity of
the machine. Best acceleration allow the spindle to follow the tool path more closely.
Craig
