Reply with QuoteMacropump.m1s runs I think10x/second.
Remember to enable it in General Config.
How to get a VBscript to run at start up?
Good morning MACH users.
I am using MACH3 and would like to have a VBSCRIPT program run all the time (easy with a DO LOOP). However, I can figure out how to get the script to start running when MACH starts. I would prefer not to start it with an M-Code as I am sure I would forget to start it every time I start MACH 3.
Any idea how I could do this?
Chris D.
Similar Threads:
Re: How to get a VBscript to run at start up?
Macropump.m1s runs I think10x/second.
Remember to enable it in General Config.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Re: How to get a VBscript to run at start up?
Thanks Gerry!
