Mach3 R3.043.062Code "G92.2"
'Call SetDRO(24,0)
Call SetDRO(2, ABS(GetOEMDRO(1001)))
Hi gang,
While I was configuring my auto tool zero button on the "Program Run" tab, I misread some instructions and deleted the code on the "set Z" button under the "Offsets" tab. This button is located on the top left corner of the page.
Could anyone check what the "factory" code is for that button and paste it here? I tried resetting to standard settings but it would only go back 2 sessions and it gave me an error when I tried. This button doesn't work for me anymore, and while my auto z probe does work, I'd like to have the Set Z button working again.
Any help would be VERY much appreciated. Thank you!
Similar Threads:
Mach3 R3.043.062Code "G92.2"
'Call SetDRO(24,0)
Call SetDRO(2, ABS(GetOEMDRO(1001)))
You are welcome, good luck!