- Pin out for Primeweld 60 to WarpRunner/TMC3in1
-
Member
Pin out for Primeweld 60 to WarpRunner/TMC3in1
Hey guys,
Not sure what to do about pin 3 here.
THC is not working properly so first thing I'm looking at is the hook ups to the plasma cutter.
Here's a pic showing what is happening. Torch just starts pulling up until the plasma cutter calls it quits,
Here's a page from the Primeweld manual.
Similar Threads:
-
- Pin out for Primeweld 60 to WarpRunner/TMC3in1
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules