- CNC not cutting from center.
-
Member
CNC not cutting from center.
Aloha,
Any ideas why my machine is cutting offset from x axis? The shaded line is a straight cut along the x axis from work offset 56.
These pin locations are to mill the reverse side so I am getting compounded cut error when I turn the part over.
As I read it, it seems that the first Y move is creating a new center. But I don't know why fusion is doing that. The first hole should be at Y0.
I am running Fusion360, Mach3 with ESS.
Thank you.
Lee
Last edited by Lee7771; 09-19-2019 at 02:11 AM.
Reason: Adding info.
-
-
Member
Re: CNC not cutting from center.
Last edited by Lee7771; 09-19-2019 at 02:31 AM.
-
Member
Re: CNC not cutting from center.
Last edited by Lee7771; 09-19-2019 at 02:32 AM.
-
Member
Re: CNC not cutting from center.
Compared to drawing that program makes no sense to me?
The ruler shows 36.5mm ish spacing yet nothing in that program even adds up to that?
Seems a mixture of inch and mm measurements in that?
- CNC not cutting from center.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules