Which operating system do you run on your computer?
hello, sorry for the translation
. I am looking for an advice with cnc I have this CNC machine OpenBuilds OX cnc my problem is that with arduino works well at 95%
But I decided to change to mach3 and I can not configure mach3
NEMA 23 The interface of engine + mach3 + tb6600
I already tried several configurations, but the engine does not respond, what can I do.
Thank you
Similar Threads:
Last edited by tazma; 04-13-2019 at 07:08 AM.
Which operating system do you run on your computer?
Make no mistake between my personality and my attitude.
My personality is who I am. My attitude depends on who you are.
if I fed well
this good configuration is possible to test