Need Help! How to make thread with RNR motion board in mach3?


Results 1 to 2 of 2

Thread: How to make thread with RNR motion board in mach3?

  1. #1
    Member
    Join Date
    Nov 2011
    Location
    Middle East
    Posts
    21
    Downloads
    0
    Uploads
    0

    Default How to make thread with RNR motion board in mach3?

    Hello guys.
    I use it about 3 months but I can't find solution how to get value from proximity sensor in SpindleS true
    It's not a problem to switch on in config-port and pins-Input Signals-index-port 3 pin 1 (any 1-4) and index LED in diagnostics reads signal from sensor but no True PRM value.
    Does someone found way to make thread with RNR motion board?

    How to make thread with RNR motion board in mach3?-rnr-jpg

    Similar Threads:


  2. #2
    Member
    Join Date
    Nov 2013
    Posts
    4280
    Downloads
    0
    Uploads
    0

    Default Re: How to make thread with RNR motion board in mach3?

    Hi,
    the only thing to recommend an RnR board it that its cheap.....and works sometimes/mostly.

    If you want a better result buy a US or European made motion controller.

    Craig



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

How to make thread with RNR motion board in mach3?

How to make thread with RNR motion board in mach3?