Need Help! STB4100 - Mach3 USB Motion Card question


Results 1 to 2 of 2

Thread: STB4100 - Mach3 USB Motion Card question

  1. #1
    Member
    Join Date
    Oct 2013
    Posts
    9
    Downloads
    0
    Uploads
    0

    Default STB4100 - Mach3 USB Motion Card question

    The circuit below is for the STB4100 - Mach3 USB Motion Card. My question is whether the E-Stop switch, the different limiting switches and the homing switches must be normally open switches (as indicated) or whether they can be normally closed switches?

    I also want to use 3 LJ12a3-4-z/bx Inductive probes for the homing switches. Can anybody advise me how they must be connected please.

    STB4100 - Mach3 USB Motion Card question-connectiondiagram-jpg

    Similar Threads:


  2. #2
    Member
    Join Date
    Dec 2017
    Location
    United States
    Posts
    26
    Downloads
    2
    Uploads
    1

    Default Re: STB4100 - Mach3 USB Motion Card question

    from the research i have done its handle by the software : the question i have is how to hook it up i am using a resistor from the 24 volt power source do you have a pic on how you hooked it up?



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

STB4100 - Mach3 USB Motion Card question

STB4100 - Mach3 USB Motion Card question