does anyone have any idea where I can the plug-in dll for the BL-USBMACH V3.22 motion controller board for MACH4 .
Hey guys I really need the plug in for the BL-usbmachv32 motion controller board . I found it for Mach3 but not Mach4 will the 1 for Mach 3 work in Mach 4 ?? Still very new to Mach4 but I can't seen to find where I enable the plugin's . Can anyone help on finding the correct plain for this board and /or will the 1 for mach3 work??
Similar Threads:
- Mach 3... its all good until I plug in the USB motion control card.
- Gecko 6 Axis Motion Controller (The Most Advanced Controller Available)
- 3.5mm plug terminals..(If your building a CNC controller these are worth reviewing)
- Another Plug and Play servo controller thread.
- G0704 CNC converted - Ballscrews, Controller & Power supply - plug and play
does anyone have any idea where I can the plug-in dll for the BL-USBMACH V3.22 motion controller board for MACH4 .
It's very unlikely that there is one.
The last I heard, only one of the hundreds of Chinese boards had a Mach4 plugin, and it wasn't very good.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
I don't think that any Chinese cards have a Mach4 plugin.
You could use this one to replace your BLMach card: CNCdrive - motion controls
It supports Mach4.