New Machine Build How do I control the feedrate/jogging speed arrows with a keyboard?


Results 1 to 2 of 2

Thread: How do I control the feedrate/jogging speed arrows with a keyboard?

  1. #1
    Member
    Join Date
    Nov 2015
    Posts
    3
    Downloads
    0
    Uploads
    0

    Default How do I control the feedrate/jogging speed arrows with a keyboard?

    Greetings,

    I am trying to control the arrow keys that will increase or decrease the jog speed with a keyboard. I'm quite stuck and could use some help. Thanks!

    Similar Threads:


  2. #2
    Member
    Join Date
    Apr 2004
    Location
    Oakland CA USA
    Posts
    4979
    Downloads
    0
    Uploads
    0

    Default Re: How do I control the feedrate/jogging speed arrows with a keyboard?

    Normally, the jogging feedrates are set in Motor Tuning when you indicate velocity. If it goes a lot slower than that, you might have a slow jog feedrate active. Hit the Tab key and see what it says under "Slow Jog". If it's less than 100%, you can change it with the slider. If you like having a slow jog rate sometimes, you can set it to a lower percentage, and hold down the shift key when you want to jog fast, which should make it revert to the master velocity.

    Andrew Werby
    https://computersculpture.com/


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

How do I control the feedrate/jogging speed arrows with a keyboard?

How do I control the feedrate/jogging speed arrows with a keyboard?

How do I control the feedrate/jogging speed arrows with a keyboard?