This anilam 3000M is on a milling machine that I have but that is no longer working. After asking around about a cheap-ish way to set up something newer while still keeping as much of the system as I could. I was recommended to look at Linuxcnc. I see the idea of it and have done a fair amount of reading and video watching but it all is a bit much to take in at first. Any guidance on how to go about setting this system up would be the tits. I haven't had a chance to write down what all is on the machine but I can do so if its needed. (power box, motors, encoders, etc.)
I should probably add that this is somehwat new to me but im not completely dumb to it. I run a cnc plasma and am decent with Enroute, Aspire, and Fusion 360.
Thanks in advance Kylizer

Similar Threads: