Hi,

I installed LinuxCNC, because I was really impressed by the video I saw on YouTube on how well a digitising probe worked.

My mill is running LinuxCNC without any problems.

How on earth do I add the probing features to LinuxCNC?

Is there any sample configurations I can select to give me a basic idea of what is available?

And if not - is there any step-by-step guide I can follow to get this working? There is so many little bits of information everywhere, but nothing I could find after hours-and-hours of searching to actually get this newbie-to-LinuxCNC on track with the probing.

I've done digitised probing with other software, but it was really too slow to do a big scan - it would have taken me a few days to complete.

Thanks.

Similar Threads: