Alarm wiring on Rnr motion card (Red)

[trivalb]

Hi.
I have 2 drivers HBS860H. I tried to connect alarm+ from one driver to the Input 1 of the controller, then Alarm- bridged with alarm+ on the other driver and A- to DCM (gnd for24V). I added a 24V power supply for the board. But if one driver goes in alarm the other just continues to work. Does anybody have the same issue?

Similar Threads:

• 6040 router - wiring limit switches into USB Motion Card
• rnr motion breakoutboard
• RNR Mach3 Motion Control Card - MPG connection

[dazp1976]

Hi.
I have 2 drivers HBS860H. I tried to connect alarm+ from one driver to the Input 1 of the controller, then Alarm- bridged with alarm+ on the other driver and A- to DCM (gnd for24V). I added a 24V power supply for the board. But if one driver goes in alarm the other just continues to work. Does anybody have the same issue?

Why not just connect alarm into the estop circuit if you want them all to disable when one alarms?

[trivalb]

Why not just connect alarm into the estop circuit if you want them all to disable when one alarms?

Thank u for reply. tomorrow I will try . Anytime I think I will go with cncdrive UC300eth and UCCNC cause this chinese board is not responsive in jog , not enought.

[trivalb]

Ok, I changed board. Using a standard chinese 5 axis lpt and UC100 USB , I have wired all Alm+ together to estop. All Alm- to Gnd. It works properly. Please moderator should change the board in the title. Thanks