![Home](https://maxcdn.cnczone.com/images/misc/navbit-home.png)
- New Machine Build- Need help to calculate motor size needed.
-
Member
-
-
Member
Re: Need help to calculate motor size needed.
-
Member
Re: Need help to calculate motor size needed.
take care, don't expect to much from the 8nm motor, it has twice the self inductance of your 3 nm motor. If you look at the torque diagram's you will see that it drops almost twice as fast.
So only if you stay at low RPM ( below 200 ) you have advantage. At 400 RPM they are almost the same.
if you need stronger motors, at the same speed, you need the same self inductance or lower.
-
Member
Re: Need help to calculate motor size needed.
Thanks for the answer. I have been considering this too. That at high rpm there is not significant difference... Maybe I will need servo motors for my application? But I have no clue of how to setup a servo motor system.
-
Member
Re: Need help to calculate motor size needed.
Some servo systems also use the Step Dir input like the stepper motors. I expect that this is the easy way to replace them. Again a warning, some sellers show closed loop steppers as servo system.
These still have the same issue with the higher self inductance but they stop and give a warning when they are missing to many steps
-
Member
Re: Need help to calculate motor size needed.
I know. These leadshine steppers I use are closed loop. They have encoders and never had any issue with loss of steps or accuracy. I just want to build the new bigger machine with much higher speeds.
-
Member
Re: Need help to calculate motor size needed.
Hi,
modern AC servos will eat any stepper ever made, even closed loop steppers.
The manufacturers of closed loop stepper systems claim they are as good as servos.....pure BS, they are still steppers and suffer degrading torque as the speed
increases, EXACTLY the same as open loop steppers.
If you want genuine speed and VERY generous overload capability then go for modern AC servos. I'd recommend Delta (Taiwanese made in China) or DMM ( Canadian made in China)
as two quality, well supported brands at reasonable prices.
There are even cheaper Chinese made AC servos and while I have no complaint abut quality or performance, the documentation is poor, support questionable and
worst of all.....no set up and tuning software. You have to program the drives by pushing buttons on the drive like a microwave....avoid like the plague.
I bought three 750W Delta B2 series (160,000 cpr encoder), one braked. They are direct coupled to 32mm diameter ballscrews of 5mm pitch and they accelerate up to 25m/min
in half an eye blink! My axis beds are 115kg each, so they have plenty of get up and go. Using rated torque only (not the up to three times rated torque) the axes accelerate at 0.25g,
and I could, using the overload capability get up to 0.75g acceleration. They seriously kick-arse!
Craig
![Home](https://maxcdn.cnczone.com/images/misc/navbit-home.png)
- New Machine Build- Need help to calculate motor size needed.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules