- Red Light Flashing HBS86H
-
Member
Red Light Flashing HBS86H
Hi All,
I have a 6090 cnc Machine and Once I start my cnc the X-Axis & Z-Axis works fine but the Y-Axis after a small movement get stuck and Red Light Start Flashing on its HBS86HHybrid Stepper Servo Drive.
Please check the below Video
https://we.tl/t-pqJpZrxJyt
My Motor is Easy Servo Motor 86HBM80-01-1000 leadshine.
Please help. Thanks a lot in advance.
Similar Threads:
-
-
Member
Re: Red Light Flashing HBS86H
How many times the red flashes in each cycle? if it is 7 times, it means position following error, indicating that there is a problem with the encoder feedback signal.
Potential reasons?
1. The encoder is wire broken or bad connection.
2. The motor acceleration is too large.
3. The motor is overloaded during movement.
-
Member
Did you get to the bottom of it? I have the same problem with two HBS507 and it’s driving me insane... there is NOTHING wrong with the wiring (as far as I can see but I’ve had two identical driveS do the EXACT same thing. Jog a little then trip/alarm with the 7 blips/ position following error.. I could cry!
- Red Light Flashing HBS86H
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules