Red Light Flashing HBS86H

Results 1 to 3 of 3

Thread: Red Light Flashing HBS86H

  1. #1

    Default Red Light Flashing HBS86H

    Hi All,

    I have a 6090 cnc Machine and Once I start my cnc the X-Axis & Z-Axis works fine but the Y-Axis after a small movement get stuck and Red Light Start Flashing on its HBS86HHybrid Stepper Servo Drive.

    Please check the below Video

    https://we.tl/t-pqJpZrxJyt

    My Motor is Easy Servo Motor 86HBM80-01-1000 leadshine.

    Please help. Thanks a lot in advance.

    Similar Threads:


  2. #2
    Member
    Join Date
    May 2015
    Location
    China
    Posts
    38
    Downloads
    0
    Uploads
    0

    Default Re: Red Light Flashing HBS86H

    How many times the red flashes in each cycle? if it is 7 times, it means position following error, indicating that there is a problem with the encoder feedback signal.
    Potential reasons?
    1. The encoder is wire broken or bad connection.
    2. The motor acceleration is too large.
    3. The motor is overloaded during movement.



  3. #3
    Member MOCOMAX's Avatar
    Join Date
    Apr 2019
    Posts
    0
    Downloads
    0
    Uploads
    0

    Default

    Did you get to the bottom of it? I have the same problem with two HBS507 and it’s driving me insane... there is NOTHING wrong with the wiring (as far as I can see but I’ve had two identical driveS do the EXACT same thing. Jog a little then trip/alarm with the 7 blips/ position following error.. I could cry!



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Red Light Flashing HBS86H

Red Light Flashing HBS86H