MX3660 Estop Fault on two Drives, Over Current Fault on One

Results 1 to 3 of 3

Thread: MX3660 Estop Fault on two Drives, Over Current Fault on One

  1. #1

    Default MX3660 Estop Fault on two Drives, Over Current Fault on One

    So my MX3660 powered machine stopped cold in its tracks yesterday.

    I can still move axis via a Gecko G540 that is in my control as well. This includes the steppers that were previously connected the MX3660.

    After opening the control two of the axis show a Estop fault. The other drive shows over current, even when nothing is plugged into it.

    Is there a way to reset this fault? Or is the drive damaged?

    Just to be clear, the Estop is not on in the control software (UCCNC) and can be turned off and on via the two Estop buttons succusfully. The MX3660 blinks the Estop fault on those two drives, I suspect because the third drive is over current?

    Similar Threads:


  2. #2

    Default Re: MX3660 Estop Fault on two Drives, Over Current Fault on One

    I have done some reading and it appears this is a common fault associated with the unit being fried.

    Disappointing because the drive is only a year and a half old.

    Does anybody know if there is a repair service for these?



  3. #3
    Member
    Join Date
    May 2015
    Location
    China
    Posts
    38
    Downloads
    0
    Uploads
    0

    Default Re: MX3660 Estop Fault on two Drives, Over Current Fault on One

    Hello, according to my experience, this may be caused by the damage of the internal module?s?.
    Please contact your direct supplier to deal with or replace the module.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

MX3660 Estop Fault on two Drives, Over Current Fault on One

MX3660 Estop Fault on two Drives, Over Current Fault on One