- Need Help!- wiring spindle to mx4660
-
Member
wiring spindle to mx4660
i recently purchased a mx4660 from www.steppermotorcanada.ca. i am very pleased with my purchase. i have installed it and in the process of configuring it. i have a few questions:
- concerning the wiring for the spindle, i am not certain i understand the correct procedure about "jumping the wire" i have a two lead wire from the driver of my spindle which is jumped, but i have not jumped anything on the mx4660 side because i am afraid of damaging it. the spindle is not engaging. here are two pictures, one of the driver side, and the other of the 4660 side:
- my next question is about the dip switches for the current to the stepper motors (model 23HS2430B) at 3 amps. they can run hot. i was told that i could set the dip switches to a lower value to reduce the heat. what value do you suggest?
jacques
jlroch@sjcon.ca
Similar Threads:
-
-
Member
Re: wiring spindle to mx4660
Hi Jacques, I replied your email before, as below...
I checked your spindle DDBLDV 1.0 manual that it can be controlled by external analog input as motor speed control.
However, its voltage 5V outputs is a little low for mx4660 "+10vdc in" but you can have a try .
DDBLDV 1.0 side MX4660 side
"5V " connected to " +10vdc in"
"VE" connected to "0-10v out"
"GND" connected to "EGND"
The pin14 (PWM)/pin25(GND) of DB25 on mx4660 is used for receiving PWM signal to control analog signal (voltage) output to your DDBLDV 1.0 for motor speed control.
Refer to page 10, [COLOR=inherit !important]http://www.leadshine.com/UploadFile/...4660d_V1.2.pdf , pins instructions.[/COLOR]
- Need Help!- wiring spindle to mx4660
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules