Need Help! wiring spindle to mx4660

Results 1 to 2 of 2

Thread: wiring spindle to mx4660

  1. #1
    Member
    Join Date
    Dec 2017
    Location
    Canada
    Posts
    5
    Downloads
    0
    Uploads
    0

    Default wiring spindle to mx4660


    i recently purchased a mx4660 from www.steppermotorcanada.ca. i am very pleased with my purchase. i have installed it and in the process of configuring it. i have a few questions:

    • concerning the wiring for the spindle, i am not certain i understand the correct procedure about "jumping the wire" i have a two lead wire from the driver of my spindle which is jumped, but i have not jumped anything on the mx4660 side because i am afraid of damaging it. the spindle is not engaging. here are two pictures, one of the driver side, and the other of the 4660 side:







    • my next question is about the dip switches for the current to the stepper motors (model 23HS2430B) at 3 amps. they can run hot. i was told that i could set the dip switches to a lower value to reduce the heat. what value do you suggest?


    jacques

    jlroch@sjcon.ca


    Similar Threads:
    Attached Thumbnails Attached Thumbnails wiring spindle to mx4660-leadshine-side-jpg   wiring spindle to mx4660-driver-side-jpg  


  2. #2
    Member
    Join Date
    May 2015
    Location
    China
    Posts
    38
    Downloads
    0
    Uploads
    0

    Default Re: wiring spindle to mx4660

    Hi Jacques, I replied your email before, as below...
    I checked your spindle DDBLDV 1.0 manual that it can be controlled by external analog input as motor speed control.


    However, its voltage 5V outputs is a little low for mx4660 "+10vdc in" but you can have a try .


    DDBLDV 1.0 side MX4660 side
    "5V " connected to " +10vdc in"
    "VE" connected to "0-10v out"
    "GND" connected to "EGND"


    The pin14 (PWM)/pin25(GND) of DB25 on mx4660 is used for receiving PWM signal to control analog signal (voltage) output to your DDBLDV 1.0 for motor speed control.

    Refer to page 10, [COLOR=inherit !important]http://www.leadshine.com/UploadFile/...4660d_V1.2.pdf , pins instructions.[/COLOR]






Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

wiring spindle to mx4660

wiring spindle to mx4660