CS-D508 closed loop stepper drive current

Results 1 to 3 of 3

Thread: CS-D508 closed loop stepper drive current

  1. #1
    Member
    Join Date
    Oct 2012
    Location
    Norway
    Posts
    16
    Downloads
    0
    Uploads
    0

    Default CS-D508 closed loop stepper drive current

    HI I have just setup an Emco lathe with an ELS with ball screws and closed loop steppers. For the X I have a CS-D805 driver and a nema 17 CS M2 1708 (leadshine) motor. I am new to leadshine closed loop steppers by my understanding is the current is set automatically? If this is the case it is not working correctly as the motor gets very hot (as in burning skin hot, I don't have a thermometer in my workshop but way too hot) Do I need to get the cable so I can change something in the driver setup?

    thanks

    Luke

    Similar Threads:


  2. #2
    Member
    Join Date
    May 2015
    Location
    China
    Posts
    38
    Downloads
    0
    Uploads
    0

    Default Re: CS-D508 closed loop stepper drive current

    Hi Luke,
    Thank you for supporting Leadshine products.
    The motor CS-M21708 is rated 2.5A, you need a tuning cable to set a smaller current in CS-D508 to avoid motor too hot.
    Please try to contact your direct supplier for a tuning cable "CABLE-PC" to make some tuning work, thanks.

    Best regards.



  3. #3
    Member
    Join Date
    Jan 2018
    Location
    United Kingdom
    Posts
    1516
    Downloads
    0
    Uploads
    0

    Default Re: CS-D508 closed loop stepper drive current

    If the motor is getting THAT hot are you sure it's up to the job and not too small?
    Are you sure there is no tightness/binding anywhere.

    As with brushless RC stuff.- Motors get supplied the current the motors ask for. If you gear them up or make them too tight they ask for more then they get too hot.

    It's worth you having the cable by the sounds of it.
    DB9 (serial RS232) to RJ11 connections.
    I hear different vendors wire them with different wiring so make sure what you get matches the connection terminals shown in the driver manual.
    If you don't have manual then Google search:
    leadshineusa.com › Down › CS-D508_m3.1.pdf.
    It's top result.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

CS-D508 closed loop stepper drive current

CS-D508 closed loop stepper drive current