Corrupt .xml file.
Very common with Mach3.
Always make a backup when you have everything working properly.
I setup Mach3 on a XP Home computer (it has necessary requirements for Mach3-fresh install of XP Home SP3). When I go to open the MX4660 profile, it freezes my computer and I have to power it down. If I go to load Mach3 Mill, it opens without issue.
I was running Mach3 on a laptop with a TB6560 board, so as a test, I put the MX4660 XML file in Mach3 folder and it loaded there just fine...
Any suggestions as to the problem?
Similar Threads:
Corrupt .xml file.
Very common with Mach3.
Always make a backup when you have everything working properly.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)