Leadshine D808 + ES-M22430 fault signal on mach3

[jimskeet]

Hi guys.
I have the drives and motors that i mention on my title. At the moment they are not connected to signal a fault on my bob. I am reading this on the manual.

I have already done a fault connection on my bob for the vfd. Its relay switches in case of fault and mach3 estops. From what I understand from the manual this is the same function on the drive? So I can connect all 4 of my drives fault output and vfd fault output relay in series on a single input and have mach3 estop in case of any drive or vfd fault?

Similar Threads:

• How to add Leadshine alarm signal to e-stop chain?
• Leadshine ES-D808 & ES-M23440 wont connect via protuner
• Genuine Leadshine Easy Servo Stepper Motor ES-M32320 and ES-D808 Driver
• Need Help!- Wiring Enable and Fault with Leadshine EM-705 and PMDX-126
• Fault and Reset signal in DYN2H

[jimskeet]

Anyone knows anything?