Leadshine technical support available on CNCzone.com - Page 3

Page 3 of 3 FirstFirst 123
Results 41 to 43 of 43

Thread: Leadshine technical support available on CNCzone.com

  1. #41
    Member odie_flocon's Avatar
    Join Date
    Sep 2021
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default Re: Leadshine technical support available on CNCzone.com

    I was wondering what the pinout for the serial RJ11 connector is on the HBS86H?
    I cannot find it in any documentation from Leadshine?

    Thanks.



  2. #42
    Member
    Join Date
    Nov 2011
    Location
    Mexico
    Posts
    107
    Downloads
    0
    Uploads
    0

    Default Re: Leadshine technical support available on CNCzone.com

    Hello , I just start having an issue with my MX4660, I have 3 push buttons connected to input 1, 2 and 3 fot cycle start, feed hold and stop cycle, +12v connected to OPTO1. They were working right but suddenly they are no longer working, I verified the volt between push buttons terminals (NO push buttons) they show 11.2v in normal state and drop to 2volt when I press the push butons. Any help where should i need to look for



  3. #43
    Member
    Join Date
    Sep 2005
    Location
    Indonesia
    Posts
    1195
    Downloads
    0
    Uploads
    0

    Default Re: Leadshine technical support available on CNCzone.com

    Hello Leadshine,
    Is it possible to buy replacement board for stepper motor driver DMA860H ? How much ?



Page 3 of 3 FirstFirst 123

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Leadshine technical support available on CNCzone.com

Leadshine technical support available on CNCzone.com