I made a 100mm x 100mm square. Cut plywood and then measured the cut. I adjusted the numbers so the catual cut and sofware matched. You need to reset the machine after each download of settings.
I need to know what my setting are to read in the X & Y
I have a LT-6090
My X=900 for length one pules move length is 0.0039656251
My Y=600 for length one pules move length is 0.0039656251 this is wrong what should it be
per length reads 19.828125 pluse counts reads 5000
what should i put in to make this wright
Similar Threads:
I made a 100mm x 100mm square. Cut plywood and then measured the cut. I adjusted the numbers so the catual cut and sofware matched. You need to reset the machine after each download of settings.