cnc 40w blow the fuses

Results 1 to 2 of 2

Thread: cnc 40w blow the fuses

  1. #1
    Member eliud22's Avatar
    Join Date
    Jul 2022
    Posts
    1
    Downloads
    0
    Uploads
    0

    Question cnc 40w blow the fuses

    i have a cnc laser 40w i was working good when suddenly the machine stop its a chinese machine i put a new fuse in the wire where have a fuse and again blow the fuse later check inside in the power supply have other fuse and too blow the fuse when i replace the fuse on the cord of 5AMP at 10AMP fuse someone have a idea for why the machine does not work help me

    Similar Threads:


  2. #2
    Member
    Join Date
    Jun 2005
    Location
    USA
    Posts
    1562
    Downloads
    0
    Uploads
    0

    Default Re: cnc 40w blow the fuses

    Your laser power supply might have gone bad. Disconnect power wire to laser and replace fuses again. Now power it on again and see if the fuses blow again. If they blow again with the laser tube disconnected then the supply is shorted. If the fuses do not blow then the laser tube is shorted and needs to be replaced



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

cnc 40w blow the fuses

cnc 40w blow the fuses

cnc 40w blow the fuses