- New G. Weike LC1390 Laser cutter- no power at all
-
Registered
New G. Weike LC1390 Laser cutter- no power at all
Hello-
I purchased and 80 watt LC1390N laser cutter from G. Weike in China. The machine arrived in good timing.
But I have unpacked and installed all (laser tube, water chiller, air pump, exhaust and grounded the machine)
Upon trying to to the machine on - it immediately shuts down - it throws the in machine circuit breaker or gcfi on the back of the machine and there is nothing.
I have it hooked to a power strip that remains on -
none of the external devices ie: chiller, air pump or exhaust are hooked up to the machine- they are on a separate circuit that runs fine
I have emailed G. Weike 3 times and recieved no response.
It is not the power supply.
I am frustrated at this point and am not sure what next?
any suggestions would be much appreciated.
Thanks
Sonja Pete
Similar Threads:
-
-
Member
did You ever resolve this? I am having the same issue!
Anyone know what’s going on???
- New G. Weike LC1390 Laser cutter- no power at all
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules