- Need help
-
Need help
https://imgur.com/a/ptXQ5BV
Hi,
Is there an option to engrave inner lines and cut outer lines with Rdworks or some other software?
-
-
Member
Re: Need help
Not familiar with RDwords but with typical software and approaches you'd define two tool paths.
The first as an engraving profile/contour with an engraving bit covering the outlines you want to engrave and the second for a cut profile using a cutting bit for the (outer) edge of the profile and cut them at the required depths.
Other than RDwords, have a look at SimplyCam from MR-Soft Nc Software Tools for a different 2.5D drawing and G-Code generator program that can do this.
- Need help
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules