Raycus 30w Laser Software EZCad2.0 Calibration

[LaserCutter2019]

Hello, I just got a Raycus 30w Laser cutter/engraver from China. I can't seem to get it to calibrate right on the EZCad software that it comes with, in order to engrave a small text onto a charm. The text comes out inverted, like a mirror image. Does anyone know where I can find how to calibrate it? Is it out of focus? Do I need to focus it? completely lost. Does anyone know where I can start looking? Thank you so much.

[davidgreams]

Fibre laser sources do not react with paper, wood or fabrics.

You want to test it on metals to see the reaction you get. The focus on a fibre laser is critical, potentially just +/- 0.25mm so it could just be that you do not have the correct focal position.

It will be a pain, but you might just need to do some experimentation to find the optimum focus point.

[keyencelaser]

Hello, I just got a Raycus 30w Laser cutter/engraver from China. I can't seem to get it to calibrate right on the EZCad software that it comes with, in order to engrave a small text onto a charm. The text comes out inverted, like a mirror image. Does anyone know where I can find how to calibrate it? Is it out of focus? Do I need to focus it? completely lost. Does anyone know where I can start looking? Thank you so much.

https://cdn.shopify.com/s/files/1/13...ser_manual.pdf

manual page 68-69
Thank you.